Celica Forums General Discussion Exterior Quick Question about MAF Sensor...

Just took it off my intake to clean it, and I was wondering how I can get to the actual sensor.

Does it just unscrew, the part that the temperature probe is attached to, where the o-ring is?

Doesn't say in the install section.

Thanks.

i think you just need to spray or swap it with sometime...

You need to spray that wired dark amber bulb on the side of the main shaft, then spray at the two spring wires inside one side of the main shaft. After those are clean, spray up into both sides to remove all the dirt that has collected inside. No disassembly required.

yeah..dont' try to open them up, you might cause something bad you don't want..

Thanks. I saw an o-ring, so I thought that it might unscrew somehow.