Previous Thread
Next Thread
New Reply
Print Thread
Rate Thread

Joined: Sep 2017
Posts: 5
New Member
New Member
Joined: Sep 2017
Posts: 5
Hi Guys, my first post on here so I'm a newbie to this forum.
I've just bought a pair of welcome door projector LED's, for my U.K registered Celica, the doors don't have any kind of lighting on them at the moment that lights up when the doors open & was wondering where do I get the feed from so that the lights light up when the courtesy light comes on ?, I'm pretty good with electrics & not started to take a look yet, but wanted the info so I can be sure to finish the job without delays, any help really appreciated, cheers, Tony

Joined: Sep 2017
Posts: 7
New Member
2002 Toyota Celica GT-S
New Member
2002 Toyota Celica GT-S
Joined: Sep 2017
Posts: 7
I would probably wire it to the dome light (after the switch if possible) that way you can control whether it comes on or not when you open the door and so it isn't on after you shut the door.

Joined: Sep 2017
Posts: 5
New Member
New Member
Joined: Sep 2017
Posts: 5
By 'Dome light' do you mean the courtesy light between. The visors ? If so that was my plan, but do the wires run into the passenger & drivers side kick panels where I can take a feed for them into the doors ? Cheers Tony

Joined: Sep 2017
Posts: 7
New Member
2002 Toyota Celica GT-S
New Member
2002 Toyota Celica GT-S
Joined: Sep 2017
Posts: 7
From what I've researched, you can run your positive wire through the fuse for the dome (or courtesy) light to each of your doors, but you will have to run the negative wire from the switch of the courtesy light to make sure the lights shut off when they are supposed to. I'll leave a link to the thread where I found the information, but they recommend you replace the light between the sun visors with an LED before adding any more lights. http://www.newcelica.org/forums/showthread.php?t=319504

Hope this helps
~Mike

Joined: Sep 2017
Posts: 5
New Member
New Member
Joined: Sep 2017
Posts: 5
Cheers Mike, so my understanding of this is that the gradual dimming of the Dome light is controlled through the ground wire rather than the live feed ? Is that correct ? Cheers Tony

Last edited by Jinxy1965; Sep 13, 2017 12:05am.

Joined: Sep 2017
Posts: 7
New Member
2002 Toyota Celica GT-S
New Member
2002 Toyota Celica GT-S
Joined: Sep 2017
Posts: 7
That's my understanding, you could check by powering the lights through the fuse and holding the ground to your frame or another known ground just to check, but if it is through the ground you'll have to run the wire from the dome light smirk

Cheers Mike

Joined: Sep 2017
Posts: 5
New Member
New Member
Joined: Sep 2017
Posts: 5
Thanks Mike for your reply, I spent around 3 hours yesterday on the car trying to logically think it all through with an illuminated electrical tester etc & I came away at the end of the day still scratching my head, ive never been able to grasp the concept of switched earths, probably because I think too logically :-) I.e normally Red = Live & Black = Earth/Ground ,anyway I have enlisted the help of an Auto electrician friend who's willing to do it for me providing I can put the projectors in the doors & run the cable into the cabin via the door trunking, small price to pay as that I have no problem doing, plus it'll be cheaper for me. I was going to use the hole saw to put a hole in the bottom of the actual door until I saw a boxed in section to the rear of the inner door panel which seems like an obvious place to put the light units, so I'm going to go with this. I will try & post a picture when its done, your help has been valuable to me thank you, even if you were the only one kind enough to comment, cheers, Tony

Joined: Sep 2017
Posts: 7
New Member
2002 Toyota Celica GT-S
New Member
2002 Toyota Celica GT-S
Joined: Sep 2017
Posts: 7
Anytime man, I'm really interested to see how it turns out (I might do this to my celica someday). If you ever have any more projects that you need help on I've enjoyed discussing this and I'd be glad to try to help.

Best of luck, Cheers
Mike

Joined: Sep 2017
Posts: 5
New Member
New Member
Joined: Sep 2017
Posts: 5
Cheers Mike really appreciated, so far I've managed to get the projectors fixed into in each door and feed the extended wires through the rubber trunking from the door to the body ( that was a real pain in the a** !!) just waiting for an Auto electrician friend of mine to come round and do the hard wiring then I should be all set, will post pics when it's done 👍👍👍

Join the conversation - Register Now or Log In to add your comment


Link Copied to Clipboard
Member Spotlight
gtsbill01
gtsbill01
2001 Toyota Celica
New York

Posts: 50
Joined: December 2003
Show All Member Profiles 
Recent Topics
2zz pcv valve
by D4ngerousbry - Apr 23, 2024 11:55am
Carcept front lip in 2024
by IM__ACE - Apr 21, 2024 9:05pm
Blitz / trial supercharger 2zz
by CheUK87 - Apr 19, 2024 4:09pm
Need Trd aid supercharger hood
by BlitzzKong - Apr 17, 2024 11:43am
Any good air intakes?
by AtomicBoi360 - Mar 31, 2024 8:25am
Urgent
by SoloXKay - Mar 19, 2024 11:58am
00-05 Celica Part out
by TM0202 - Nov 16, 2023 5:48pm
Customize Your Toyota Celica Privacy Policy · About · Contact
Privacy Policy · About · Contact
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
© CelicaHobby.com, 2001-2024
Powered by UBB.threads™ PHP Forum Software 8.0.0
(Preview build 20230331)