TRD Rear Strut Bar
By John Unever

Step 1. Remove the rear interior pieces. (tray, two side panels) They will be held in by snaps, pins, screws, and the side panels both have 1 bolt.
*Now this is where you decide whether or not you want to keep the interior pieces. For now i will show you have to install the bar without the interior.

Step 2. Remove the seat belt hooking mechanism and place the bar in place behind it and then thread the bolt back through.
[Linked Image]

Step 3. With the bar properly positioned mark the holes for the bottom piece. You will have to drill two holes for the bottom bracket. Now thread all the bolts, tighten them down, make sure the rear seats still lock into place and take it for a test drive!
[Linked Image]