Celica Forums General Discussion Exterior how do i install new fog light bulbs?

I just got the MTECH light kit and got my low/high beams in no prob, but does anyone have the link on this site for the fog lightbulb replacement procedure, i know i have to take off the bumper but where are all the screws. I'd rather do it right then break something.

Install guides...
https://celicahobby.com/ubbthreads/postlist.php?Board=UBB15&sb=2

Dude, Its easier than you think. You don't have to remove your bumper.. Just jack up your car (fornt end)... Look underneath where your fog lights are located.. On the back end of the fog light, just twist off the cap and you're in... Change the bulb and replace the cap. You're done.

This is what you Do.. Jack your car up... Remove any plastics covering access to your foglights. Once you locate them. Twist off the back cover. Remove and change the bulb. Replace the cap.. That is all the steps that you have to take

1

One of the pic doesnt work but seems easy enough.
Thanks

No prob

INSTALL GUIDES >> EXTERIOR >> Fog Lights - How to replace without removing bumper
https://celicahobby.com/ubbthreads/thread.f_135454_0_collapsed_2__1.html

there is already a guide for this...

Hey Isaac, I think that that guide only made things a little more difficult than it really is.

did you read the guide? its actually very simple... the guide is extremely basic

in your example, you even used one of the pictures from that guide

That was the only picture needed to do the whole thing. Im sure that they could figure out how to remove the underbody plastics.. and what was the purpose of all of the arrows except to confuse everyone. The only time I needed a tool to do this was to remove the plastics. So like I said B4 the whole thing was very confusing, Even the person who made the post private messageed me and told me that it was too confusing for him then I got a reply that my was was way more simpler

if you have stock bumber then you should remove them for easier/cleaner install..

That may B our argument

^^^ damn bro i didn't know it was that simple i have some new foglight bulbs and was dying to install them...i might do this install on friday...

thanks guys i got it but unfortunatly my driver side fog light bulb burned out the same day for some reason.

Finger prints

Actually I just removed it and I cracked it when I put it in. Thats what I get for rushing the job. I blame it on the rain.

funny. i installed my MTECHs like this past weekend. they took a couple drops and bangs and worked fine.haaa. guess i got lucky.