Celica Forums General Discussion Exterior Getting in dash fuse out

This may sound like a stupid question, but ive been fidling around with my dash, I have taken everything apart, and still have trouble getting to the wire I need. I am, as some of yall know, cutting the wire to disable my DRLs. I cant get the small fuse box its in out though! I see there is a clip type thing on the right hand side, where the arrow is pointing too, but is that all it takes to get that single fuse box out? I have huge hands so its hard to get in far enough, and better yet pull the dang thing out. Please help!

u baboon

i think so, probably just gotta push a little clip in and pull.

lol man thats funny

yup push in the clip and wiggle like hell. be careful not to break any pins though. i think if you open the fuse box door to the side you can get a different angle and maybe use a flathead screw driver to help pry it out. thats a wire harness not a fuse

weasal and baboon..

just use the needle nose plyer to push in the clip and pull out..

remove the whole center counsle

you don't even need to take it out. just cut the wire and tape it up.