Celica Forums General Discussion Exterior Anyone know where or how to make a water shield for CAI?

my car has been trippin out in the rain lately and i donno if its my pulleys or belts or cai.. anyone know where i can get a water shield?

make one out of sheet metal.

yup

They have em at peps too, I think like 10 bucks.

damn~ I have same problem in the rain.
I dont know how your car trippin out but mine is...like this..
I was steppin on gas and all of sudden my car doesn;t go even if I give more gas. and then car goes normal. hehe
does pepboys sell intake shield for $10? I think I need that 2

also pluggin up those holes especially next to the wheel that can fling water onto the filter might help if you haven't already done that. it's probably not creating enough suction at lower rpms to pull it through a damp filter, but when you step on the gas and get past a certain rpms it probably works better.

You could always buy the splash gurad they have in the ecelica store. It's a litte more expensive but it will look nicer

lol...SAME SHIT with me!!

Assuming you have CAI

1. Remove the front bumper.
2. Get a duct tape (black or grey, it don't matter).
3. Tape all the holes.
4. Put bumper back and you are done.

lol i9 wish i had a CAI to complain about