Celica Forums General Discussion Exterior Wiring.

Im going to install my angel eyes in a few days and i need help with wiring. Heres what I have, both my angel eyes, 4 red 1.7 volt 3000mcd LEDS a bunch of 220 ohms resistors a red rocker switch and a lot of 16/14 gauge wire. I want to put the switch in 1 of the little cover things near the driver side door. Who wants to help?

Look on the firewall and find the little rubber grommet... pull 3 wires through there wire one to the battery, splice one and run it to the angel eyes (make sure to throw on your resistor) then ummm run the other one out the other side of the led. then wire the 3 to the switch ( the battery to the power source the positive to the positive and the negative to whatever is left) then you need to dremel out one of the blanks on the dash afix the switch and enjoy... Hope this helps

Is this diagram correct? the left prong on the switch is supply volts, the center is on acc. and the right is ground. could i just go from the ground prong on the switch to any metal on the car instead of going all the way back to the negative terminal? sorry about my shitty drawing.

sorry pic didnt work.

^nice drawing lol... you better post some pics when you are done