Hi! I’m new to this forum. I have a 2001 GT. After many aftermarket parts installed over the years I could never figure out how to properly install a cold air intake. I’ve tried to no avail multiple times with different kits but it’s always the same. It always ends up throwing multiple vacuum codes and the car slowly starts to shut off after. I have no clue where to put the extra lines and the extra harness after the install. The stock air filter box has a built in idle control module thing and I’m just completely lost at this point. Please help point me in the right direction. Thank you!
Hey, which parts from the stock intake did you reuse? There is a vacuum line that has to be attached to the pipe as well, the MAF should be reused, and so on. Could you attach some photos / videos of the intake?
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
