Celica Forums General Discussion Exterior Question on Reverse Indiglo Install

I just ordered my AC reverse indiglo from you guys. I was expecting a switch, but it has a touch key. I was just wondering if you have any suggestions for installing it so that its not just a tab sticking out of the plastic. Also just wonderin if im missin anything, on the site it says it includes a remote-mount switch to control the colors, is that what the touch key is or am i missing something?

[ 12-02-2002, 06:40 PM: Message edited by: supermatt ]

matt,

yes, the plastic tab is the module to change colors. if you look on the left of the steering wheel, you'll notice the lil knob to adjust the brightness of the stock gauges. below and to the right of that you'll find 3 empty slots. what i did was pop one of them out and mounted it on there and shoved it back in so that all you see is a tab on there and the wiring is all behind it, inside the dash. hope i've helped.

u did, thanks a lot

Yeah, I did the same thing that Eugic did. Its a clean setup if you do it that way.

on my indiglo gauges, the touch pad had a sticky side. i just peeled off the protective seal then stuck it to my empty slot. i didnt have to take off the slot because the pad has to stick to something. i ran the wire thru the bottom crack of it. looks nice!

thanks for the ideas, any1 got pics?

here are some pix, you can't really see them because they are both bad shots but it's the best i can do...

thanks for the pics eugic, looks great