Celica Forums General Discussion Exterior bluebats kit didnt work

hey whats going on? i am disapointed today went to put on the headlight tint and everything was going well untill i had to put the piece on that goes above the main headlight projector, just wouldnt follow the curves of the light. would get the piece layed down nice in the front then the back of it would bunch up. did this for about a half hour then started trimming.. didnt work. let me know what has to be done so i can order another kit...

you have to lay them down and trim to fit... pm or email Bat for advice

That's a very good question, because i just put on "Virgilson"s headlight overlay kit today. This is what i did for mine and his, get a razor blade, and hold that piece down, then cut directly down the middle of it, make sure you use a little bit of pressure so it completely cuts the FIRST time, thats important you do that, then put on the piece as two separate pieces, now you will definitely notice how much easier it is!!!

did you use soap and water to lubricate the surface so you can slide the piece into position before it permanently adheres?

doing this definitely helps

mine came in pre cut in the middle alreadyso it was easier to put on. your about the 3rd or 4th person who posted this problem but its an easy fix once its cut

can you notice the cut?

i'd rather not have a cut if i were to get it, imo.

its a sticker so obviously its noticable up close you cant really tell unless your looking at it. theres gonna be overlapping coz its like 8 or 9 diffrent pieces so your still gonna see cuts(ie conection points up close)checkkout mine and evryone elses you cant see them

Yup thats true, here is a close up pic of mine, and i cut my piece down the middle, the piece that we're talking about is the one that he highlighted in the 1st post, bascially the little bulge on top of the headlight area.

Here's a much better picture for all of you to see.

And I can't see the line in the pics I posted, so its absolutely fine to trim through the middle, hoped this helps you/anyone else.

and heres mine you can see where i cut it in the middle its smoked so its easier too see where the cut is

marco you wanna install mine?!

yeah i used soapy water so i could move the pieces around. thanks for the help,i am just going to order another kit and give it another go.cutting the piece in question would make a huge difference.

hahaha, thx Omar..for helping me man...!!! , Ask Omar about Vinly Overlays, haha has a bunch on his!!!

hucke150

Pls get a S2000 antenne...your VS2 kit doesn't look right with that stock lighting rod antenna...

Got any updated pics with your new bumper? I'd like to add them to my Gallery. I saw the ones in your Link, butv bigger ones would be better .

Bat-

Essential! And an exacto knife works great for trimming, or sewing scissors