After I installed my intake I let the engine run for a few minutes for the computer to learn...I drove it around the block and my car was very sluggish...do I need to keep driving it for the computer to finish learning?
If its a CAI system, make sure you have the right sensor connected to the system. AEM's system leaves a factory connector unused. My damn check engine light stays on all the time, but I dont have any performance issues. If you had a spare connector after the install, you may want to swap it.
If you're not living on the edge, you're taking up too much damn space! 2000 Black GTS AEM CAI HKS Hi-Power Cat-back AEM Strut Tower Brace AEM Tru-Power Pulley TRD Quick Shift Kit Momo Gear Knob Euro Clear Side Markers Carbon Fiber Taillights Carbon Fiber Dash Insert Konig Absolute Opal 18s Nitto NT 555 225/35ZR-18s TRD Performance Springs Coming soon... TRD LSD TRD Header & Downpipe Hi-Flo Cat Head Port n Polish Apex-i SAFC Body Kit
i just installed an AEM cai in my brother's car and someone told me to reset the ECU and let the engine run for about a minute. The intake is great and the pick up is very noticeable.
What do you guys do w/ the unused factory wiring? just bundle it up?? and does everyone has the same problem as MichaelH has where his check engine light came on after installing the intake? i'm guessing the light kinda get annoying if it stayed on all the time like that? any other suggestion??
as far as your CAI is concerned, go through your instructions again and make sure all the screws are joint screws are tightened and all the hoses are in their correct positions.
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
sorry about the continuous replied. computer is supa slow so i didn't know 
