Celica Forums General Discussion Exterior Varad Underglo

I kno i just replied on an older one, but i figured id start this one. I had my varad kit on my old truck and just zip tied em to it because the mounting brackets didnt fit the lights, so i tossed em. so im wondering if theres anyway i can mount these suckas without em. thanx

yea...its easy, if its the flat or round tubes, there many ziptie points

oh kick ass, yea theyre the little flat ones, but when i looked i couldnt tell if there were any zip tie spots

front is ez,use plastics/radiator/bumper. Rear i tied into misc stuff up there, left side i attached to ebrake lines and brake stuff. The only hard on is right side because there's jackshit over there, you have to drill two small holes in floor, that seems to be what everyone does

well i got everything mounted awesome, but when i did all the wiring, i kinda ghetto rigged it, when i connected it to the battery, the lights would come on and stay on regardless if the switch was on or off and the wire got really fuckin hot and turned bright red so im not sure if its how i wired it or what, but its pissin me off

alright i figured out what i did wrong i jus realized it. the positives run together, then to the pos of the switch then to pos on battery, the negatives run together, then just to neg of switch, not on battery. i accidentally ran it to the negative also, OOOOOPS